Integrated amplifier to which the polish was further applied based on E-210 and which was developed as more highly complete amplifier. The power transistor for the Oide power audios excellent in many characteristics, such as a current gain linearity and switching, is adopted as a power amplifier. This element is constituted from a parallel push pull, it attaches on a large-sized heat sink, and efficient heat dissipation processing is carried out. Moreover, operation to heat adopts the power MOS FET of the negative characteristic as a drive stage, the power transistor and heat inclination of the right characteristic are offset, and stable operation is guaranteed to it. The principle of this circuit lowers the impedance of the input terminal which is a return side first, detects current, carries out I-V (current-voltage) conversion of that current with a transformer impedance amplifier, and makes an output signal.
Therefore, since the impedance of a return input portion is low, it is hard to generate phase rotation, and there is almost no necessity for a phase guarantee. Thereby, since many characteristics are sharply improvable by a little NFB, it excelled in dynamic characteristics, such as a standup, and the natural energy response has been obtained. Since a straight signal course is constituted at the shortest, the logic relay control system which controls a relay electronically has been adopted. Adopting the sealed type relay for communication industry as the relay used for this, the contact is the crossbar twin system plated with gold, and is using the thing of low contact resistance and quantity durability. Tone control of the added type active filter system used for a graphic equalizer is carried in tone control. From this system, it passes straight, and if needed, an original flat signal is another, and makes the characteristic, and it has a structure more advantageous to sound quality than the conventional tone control according to making it adjust from a flat signal by it. The power transformer of the large power capacity of about 400 VA is used for a power-source part. Moreover, two 22,000-micro F things are carried in the aluminum electrolytic capacitor which changes into a direct current the pulsating current which passed the commutator. The logarithm compression type output peak power meter is carried. The balance input is carried.The speaker terminal which can respond also to a thick speaker cable is carried. It is used, changing two lines or bi-wiring connection is possible.
Volume and the remote commander in whom an input change is possible are attached. The slot for option boards is carried and it can extend on the board corresponding to an AAB standard (Accuphase Analog Bus). Rated continuation average output (Both channel operation, 20Hz - 20kHz). 115 W/ch (4ohms) 105 W/ch (6ohms) 90 W/ch (8ohms). 0.04% (4ohms - 16-ohm load). High Level input: 20Hz-20kHz+0 -0.2 dB (at the time of a rated continuation average output). Input sensitivity/impedance (An Output power / EIA1W output).High Level input: 213mV/22.5mV/20kohm Balanced input: 213mV/22.5mV/40kohm. High Level input -> output: 42dB. At the time of an Output power S/N. Low-pitched sound (300Hz): 10dB (50Hz) Loud sound (3kHz): 10dB (20kHz).
Logarithm compression type peak level display dB scale and the output Direct reading at the time of 8-ohm load. Conformity impedance: 4ohms - 100ohms. 30W (at the time of no inputting) 220W (Electrical Appliance and Material Control Law) 336W (at the time of an 8-ohm load Output power). Width 475x height 150x depth of 422mm.
AA -- type and two pieces. Width 45x height 136x depth of 18mm. Line-in board Line-9 (6,000yen). The common high-level input terminal of an imbalanced system.
Analog signals, such as CD player and a tuner, are played. Analog disc input board AD-9 (30,000yen).
All cartridges are supported by loading of a high gain equalizer. With an internal DIP switch, a MM/MC change, MC input impedance, and Subsonic-Filter on/off can be set up. Gain: 36dB Input impedance: 47kohm.
Gain: 62dB Input impedance: 10, a 30 or 100-ohm change. Line-in board Line-10 (8,000yen).
Analog disc input board AD-10 (50,000yen). All cartridges are supported by loading of a highly efficient high gain equalizer. Gain: 29dB Input impedance: 47kohm. Gain: 60dB Input impedance: 10, a 30 or 100-ohm change.
The item "NEW GOLDEN ACCUPHASE E-211 MADE IN JAPAN INTEGRATED STEREO AMPLIFIER RECEIVER" is in sale since Tuesday, November 19, 2019. This item is in the category "TV, Video & Audio\Heim-Audio & HiFi\Verstärker & Vorverstärker". The seller is "ikebana007" and is located in Dublin. This item can be shipped worldwide.